If you are looking for an advanced Remote Controller for QLab and GObutton and don’t want to spend a lot?
Then Check out this DIY BOX



The functionality goes up to:

  • On-Board Buttons for GO, STOP, Prev CUE, Next CUE, Volume Up/Down.
  • Very reliable Wireless Remote Control
  • Built in USB-Audio Interface (Stereo Line-Level Output at 16bit 44,1kHz.
  • Built in USB to/from Serial MIDI Interface
  • Second Midi output to control a Backup Machine
  • Change between different function modes for Midi output and Buttons
  • Works with OSX and iOS without any driver. Plug n Play!
It comes with finished and tested Firmware and Schematics !
So no coding skills needed!
But if you wish… the Source Code is available too.